Samsung DVDVR300 Quick Setup Manual

Quick Setup Guide
Step Getting Connected
S t e p
Select one of the following three types of connections:
Antenna + DVD Recorder-VCR + TV : No Cable Box
Antenna + Set-Top Box + DVD Recorder-VCR + TV : No Cable Box
Antenna + Cable Box + DVD Recorder-VCR + TV
Antenna + DVD Recorder-VCR + TV : No Cable Box
C Samsung Electronics
IN
COMPONENT (FROM ANT.)
AUDIO OUT VIDEO OUT
LINE OUT LINE IN 1
R Y R R R R
AUDIO AUDIO
RF RF
L C B /P B L L L L
DVD Recorder-VCR
DIGITAL AUDIO OUT
C /P
R R
OUT OUT
OPTICAL (TO TV) (TO TV)
COAXIAL VIDEO VIDEO
TV
Step
Getting Connected
Step
Setup
Step
Basic Operation
The Recorder will only record on
DVD-R, DVD-RW and DVD-RAM discs.
Connect the signal source to the DVD
Recorder-VCR
Use an antenna cable to connect the signal source com-
ing from the antenna or wall to the VHF/UHF RF-IN jack
on the DVD Recorder-VCR.
Connect the DVD Recorder-VCR to the TV
Use the supplied RF cable to connect RF-OUT on the
DVD Recorder-VCR to the ANT jack on the TV. Then use
the Video/Audio Cable to connect ANALOG AUDIO
OUT(R/L)/VIDEO OUT jacks on the DVD Recorder-VCR to
the Audio & Video jacks on the TV.
If your TV has an S-Video jack, you can use S-Video
cable instead of the yellow video connector on the
Video/Audio cable.
If your TV has Component video jacks, you can use
component cables instead of the yellow video con-
nector on the Video/Audio cable. Press the
Progressive out button on the front of your DVD
Recorder-VCR to 480p/480i video output mode. If
your TV supports progressive scan, select 480p.
If you have an AV amplifier
Connect either audio cables from the ANALOG AUDIO
OUT jacks on the DVD Recorder-VCR to the LINE IN jacks
on your AV amplifier, or a digital cable from the DIGITAL
AUDIO OUT (COAXIAL or OPTICAL) jack on the DVD
Recorder-VCR to the DIGITAL AUDIO IN jack on your AV
amplifier.
1
Printed in Korea