Table of Contents
Advertisement
5.4. Error Message
5.4.1. Device Disconnection
If the BLE is disconnected on the mobile device, Mobile app will display "S-Patch is
disconnected" message, Figure 1
5.4.2. Abnormal Signal Detect
In case of Mobile app detects an invalid signal, assume LEAD OFF state and an error notification
pop-up will appear, as shown below in Figure 2. Press "OK" to turn off the pop-up. After valid
signal is detected, it's changed to LEAD ON state.
Figure 1
Figure 2
5.4.3. Low Battery Mode
If the battery level is less than 10%, you will get a notification that "Battery is too low", Figure 3.
Press OK to turn off notifications.
When the battery runs out, you will get a notification that "Change the Battery!", Figure 4. Press
OK to turn off notifications. And then you need to change the battery.
5.4.4. Low Remaining Recording Time
When the recording time is finished, "Recording time is over, visit the hospital" notification will
appear, as shown below in Figure 5.
Samsung Confidential
[22]
Advertisement
Table of Contents
