Resetting The Pin Code - Victron energy Blue Smart IP67 Manual

5.3.2. Resetting the PIN code

If the PIN code is forgotten or lost, it can be easily reset to the default 000000 using the VictronConnect app.
Using VictronConnect
To reset the Bluetooth PIN code:
a. Locate the blue smart charger in the LOCAL page and select the 'device options' icon (three vertical dots) on the right side
of the description.
b. Select 'Reset PIN code' from the pop-up prompt.
c. Enter the PUK code and select 'OK'. The PUK code is located on a label stuck to the back of the blue smart charger.
DURING THIS PROCEDURE:
a. The PIN code is reset to default (000000)
b. Any active Bluetooth connections are disconnected
c. All Bluetooth pairing information is cleared
Subsequently, before attempting to re-connect it's also necessary to remove/clear the blue smart charger
Bluetooth pairing information from any devices (mobile phones or tablets) that were previously paired.
Page 16
Blue Smart IP67 Charger
Setup