Freeze Protection - Pentair IntelliSync 523404 User Manual

15

Freeze Protection

(Set Temperature and Pump Speed)
To access the Freeze Protection page from
the Dashboard, tap the pump name (or the
water, or air sensor), then tap the Settings
icon (top right). Tap Freeze Protection. See
page 18.
Freeze protection (IntelliFlo pump, water and
air sensor): Select ON to enable freeze pro-
tection and Off to disable freeze protection.
Start Temperature: Use the slide to set the
start temperature at which freeze protection
will start the pool pump.
End Temperature: Use the slide to set the
end temperature to stop the pool pump and
freeze protection.
Pump Speed: Set the pump speed to circulate
the pool/spa water during freeze conditions.
Note: The main pool filter circulation pump is freeze protected as long as
FREEZE PROTECTION is set to ON. The heater will not activate during a
Freeze Protection period unless it is manually turned on.
Note: If the pool pump is running a schedule, it can be manually turned on
to override the Freeze protection during a freeze condition, if the outdoor
air temperature sensor detects the temperature is getting close to freez-
ing (36°F). The system detects all devices that have Freeze Protection ON,
and activates the device to stop the pipes from freezing. If freeze protec-
tion is only applied to one body of water.
Note: If the pool or spa is running a schedule or operated manually, this
will override freeze protection.
IntelliSync Control and Monitoring System User's Guide