Page 1
& Network Connection for Verizon Express Network Before setting up the Palm device, verify the data setting on your Express Network compatible phone is set to 115,200 bps or 230,400 bps If available (the speed setting on both the phone and the Palm device must match).
Page 2
5. Verify these settings Speed: "115,200 bps" or “230,400 bps” (if available) and Flow Ctl: “On” (remember the speed setting on both the Palm and the phone must match) Tap "OK twice Network Configuration 6. From the drop down list (upper right), select "Network".
Page 3
Tap End and select “Send CR:” Tap End and select “Send:” / enter “ATDT#777” Tap End and select “Send CR:” Tap End and select “Delay:” / enter “CONNECT” Leave “End” as the last parameter 11. Tap OK twice Palm 4.0(m505,m500,m125) Xpress Ntwk (setup).doc...
Page 4
If the phone fails to disconnect you can press the "End" key to end the call. You should always disconnect on your Palm™ first to ensure the Palm™ application terminates correctly and to ensure your phone doesn't automatically initiate another call if it senses the Palm™...
Need help?
Do you have a question about the m505 Series and is the answer not in the manual?
Questions and answers