Introduction; Overview; Required Tools; Related Documents - Gilbarco Veeder-Root Encore S Enhanced FlexPay EMV CRING Start-Up/Service Manual

Overview

1 – Introduction
Overview
This manual provides start-up and service information for FlexPay
components mounted on Encore
includes procedures for activation of the FlexPay EMV CRIND and the setting of all site
equipment configurable addresses.
The setup/configuration of the following equipment is described in this manual:
• FlexPay EMV CRIND Display
• FlexPay EMV CRIND Keypad
• FlexPay Card Reader
The equipment is part of a Local Area Network (LAN) that uses Ethernet
Control Protocol/Internet Protocol (TCP/IP) addressing. Each piece of equipment must be
allocated an address based on the existing site LAN address structure.
The following are the additional pay at the pump equipment addresses that must be set during
installation:
Equipment
FlexPay EMV
CRINDs
The subnet mask for all LAN equipment must be set to 255.255.255.0.

Required Tools

CRIND Diagnostic Card (Q12534-170) is required to install the FlexPay EMV CRIND
components mounted on Encore S Enhanced (units with an E-CIM bezel) FlexPay units.

Related Documents

Document
Number
MDE-3804
MDE-3985
MDE-5062
MDE-5118
MDE-5314
MDE-5386
MDE-4771H Encore® S Enhanced FlexPay™ EMV® CRIND® Start-up/Service Manual · November 2019
S Enhanced (units with an E-CIM
®
Address
10.5.48.71, for pumping position # 1
10.5.48.103, for pumping position # 32
Title
Encore and Eclipse Start-up/Service Manual
®
Encore Installation Manual
FlexPay Maintenance Tool for FlexPay/SPOT CRIND System • CRIND and TRIND
EMV Troubleshooting Guide for Canada
Insite360 Remote Management Installation, Start-up, and
™
Service Manual
Hybrid Card Reader S (HCRS) Kit (M13940KXXX) Installation
Instructions

Introduction

EMV CRIND
™ ® ®
bezel) FlexPay units. It
™
Transmission
®
GOLD Library
SM
• Encore and Eclipse
• Service Manual
• Encore and Eclipse
• Encore and Eclipse Installers
• Footprint & Elevation Library
®
• FlexPay EMV
• CRIND and TRIND
• Encore and Eclipse Installers
• Encore and Eclipse
• FlexPay EMV
• POS Peripheral Devices
• FlexPay EPP and SCR
• FlexPay IV
Encore and Eclipse
Page 1-1