Immobiliser - jcb 8014 CTS Operator's Manual

0 Ignition off/engine stop position
2 Glow plug position

Immobiliser

(if installed)
There are two different JCB immobiliser systems, one uses a keypad and the other a unique key system.
If your machine has an immobiliser system installed, then your JCB dealer should enable the system as part
of the standard machine Installation. If you prefer that the system is not enabled, then you must tell your JCB
dealer. Your JCB dealer can enable the system at a later date. Machines with immobilisers installed should
always be parked as per the instructions in the operators manual.
Introduction
Before attempting to disarm the immobiliser check that the machine is ready to start and that you have your
four digit PIN (Product Identification Number) code available.
The green LED (Light Emitting Diode) will illuminate every time that a keypad button is fully depressed. Do not
operate buttons with sharp objects, they may damage and disable the keypad.
If you make an error entering your PIN code and you realise this before pressing the ENT button then pressing
the MD button cancels inputs and allows you to re-commence.
If the PIN code is incorrectly entered five times the immobiliser will lock for 15min. In this event it is
recommended that you contact the machine owner for confirmation of the PIN code.
The PIN code will have to be entered every time that the ignition is switched off for longer than two minutes.
To Disarm the Immobiliser to Allow the Machine to be Used
1. Put the ignition key in the ignition switch. Turn the ignition key to position 1.
2. Enter your four digit PIN code using the keypad.
3. Push the 'ENT' button. The LED will come on for three seconds if the PIN code is correct and the machine
can be started.
4. If an incorrect PIN code is entered the unit will lock. The LED will flash twice quickly, pause and then flash
twice again and will continue this pattern until the ignition key is turned to the off position. In this event
return to step 1 to try again.
4.1. After five failed tries the system will lock.
Duration: 15min
42
Figure 29.
0
1
2
1 Ignition on position
3 Crank position
9821/6100-4
Starting the Engine
3
Operation
42