Sealey AP3020 Instructions

Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these instructions,
and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
Refer to
Instruction
Manual
1. SAFETY
WARNING! Ensure Health & Safety, local authority, and general workshop practice regulations are adhered to when using this bench.
‰
Locate bench in a suitable working area.
9
Keep the work area clean, uncluttered and ensure there is adequate lighting.
9
WARNING! Use bench on level and solid ground, preferably concrete. Avoid tarmacadam since the bench may sink into the surface.
‰
Keep the bench clean and tidy in accordance with good workshop practice.
9
Keep children and unauthorised persons away from the working area.
9
WARNING! This bench is not electrically insulated and is therefore not suitable for electrical repairs of any sort.
‰
DO NOT use the bench for any purpose other than that for which it is designed.
8
DO NOT undertake work on the bench without the work piece being adequately secured. Use clamps or a vice (not included) to secure
8
the work piece, both available from your Sealey dealer.
DO NOT use the bench out of doors.
8
DO NOT get the bench wet or use in damp or wet locations or areas where there is condensation.
8
DO NOT clean the bench with any solvents which may damage the paint surface.
8
2. INTRODUCTION
Manufactured throughout in 3mm steel plate for industrial durability and finished in red gloss to prevent corrosion. Sup[plied with single lockable
drawer, which can be installed on the right or the left of the workbench. Includes bottom shelf for additional storage.
3. SPECIFICATION
Model no: ................................................................. AP3020
Size (W x D x H):...................................2000 x 650 x 865mm
Maximum capacity bench top (evenly distributed): ....... 900kg
4. CONTENTS
4.1. Remove all parts and fixings from the box. Ensure that you have adequate help to remove the bench top from the box ( It is too heavy
for one person to safely lift).
4.2. . Check the contents against the parts listed. Should there be any damaged or missing parts contact your supplier immediately.
Fig.1
© Jack Sealey Limited
INSTRUCTIONS FOR
STEEL WORKBENCH 2MTR
AP3020
MODEL NO:
Original Language Version
CONTENTS
ITEM QUANTITY
STEEL WORKTOP
SHELF
LOCK AND KEYS
DRAW
DRAW RETAINING PLATE
LEGS & FIXINGS
PACK OF FIXINGS
M17 BOLTS
M17 NUTS
SERRATED WASHERS
SELF TAPPING SCREWS
AP3020| Issue2(L) 02/09/16
(1)
(1)
(1)
(1)
(1)
(4)
(14)
(14)
(14)
(2)