Sealey LED185 Manual

Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these instructions,
and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
Refer to
instruction
manual
1. SafeTy
Inspect the cable and connector for wear and damage to ensure items are safe before connecting to the power supply. If worn or
9
damaged do noT use.
Ensure the lamp is fully charged before initial use.
9
do noT charge in damp conditions.
8
do noT turn the lamp on when it is being charged.
8
do noT shine directly into your, another person's or an animal's eyes.
8
do noT allow children to use the lamp.
8
do noT handle or move the lamp whilst it is being charged.
8
do noT use the lamp if you suspect that the battery or the lamp casing is damaged.
8
do noT leave battery in a discharged state, recharge battery immediately. Before storage, fully recharge the battery, subsequently
8
recharge the battery at least once every six months of non-use.
do noT attempt to open, disassemble, modify or service the battery pack.
8
do noT crush, puncture, short external contacts or dispose of in fire or water.
8
do noT expose to temperatures above 60°C (140°).
8
Replace only with the battery pack designated for this product.
9
Recycle or dispose of used battery as stipulated by local regulations.
9
If the electrolyte in the cells gets on your skin, thoroughly wash with soap and water. If it gets in your eyes, rinse thoroughly with cool
9
water and seek immediate medical attention.
2. inTroducTion
Warm and comfortable beanie hat with a removable SMD spotlight. Features three light settings - full light (100%) medium light (75%) and low
light (50%). Positioning of the LED gives a sufficient beam of light ahead of the user. Removable light is chargeable via a USB port. Powered by
a rechargeable 3.7V 300mAh Lithium-Polymer battery.
3. SpecificaTion
Model no: ................................................................. led185
Lumen Output: ........................ 100%/75%/50%: 120/90/60lm
Operating time: .................................100%/75%/50%:2/4/5hr
Charging time: ...................................................................3hr
Battery type: ........................... 3.7V 300mAh Lithium-Polymer
IP rating:......................................................................... IPX4
Nett weight: ...................................................................... 90g
LED quantity: ....................................................................... 4
© Jack Sealey Limited
beanie haT wiTh rechargeable SpoTlighT
4 SMd led
led185
MODEL NO:
Original Language Version
LED185 Issue:2 (2,3) - 12/09/18