PURE Avanti Flow Manual

Portal > FAQs > Internet Radios and Pure Connect / The Lounge > Binding your Pure remote
control - Evoke Flow, Avanti Flow and Sensia only
Binding your Pure remote control - Evoke Flow, Avanti Flow
and Sensia only
Pure Support - UK - 2014-06-18 - in Internet Radios and Pure Connect / The Lounge

Evoke Flow and Avanti Flow

On your Flow system press 'Options' > 'Additional Settings' > 'Bind Remote'
Follow the onscreen instructions asking you to press the 'Repeat' and 'Shuffle' buttons at
the same time
Press 'Select' to confirm the bind when prompted. Your remote is now connected
If your Reach F10 remote only appears to work at very close proximity or doesn't
bind at all, please follow the instructions below.
Note you will need a device with a pointed tip - like a pen or pencil to complete
this operation
On your Flow system press 'Options' > 'Additional Settings' > 'Bind Remote'
Open the battery compartment on the back of your remote control.
When prompted to press the 'Repeat' and 'Shuffle' buttons, use a pen or pencil to press
the hardware button inside the battery compartment instead (pictured below). Your remote
is now connected.