Table of Contents
Advertisement
Available languages
Available languages
©
Using the remote-
control (fig. A)
The remote control will control up to 4
remote-controlled sockets (individually,
in groups or simultaneously).
1. Press the desired ON button of the
channel ON/ OFF button
C or D) on the remote control of
the device you wish to switch on.
The LED operating status display
will light.
2. Press the desired OFF button of the
channel ON / OFF button
B, C or D) on the remote control for
the device you wish to switch off.
The LED operating status display
will go out.
3. Confirm the ALL ON / OFF button
to switch all remote-controlled
3
sockets simultaneously.
©
Trouble-shooting
If the remote control does not
work, please check the follow-
ing points:
Prob-
The operating indica-
lem
tor
on the remote
1
control device illumi-
nates but there is no
reaction
Rem-
· Check if the battery still
has sufficient Ampere. If
edy
necessary, install a new
battery.
Prob-
lem
Rem-
edy
(A, B,
2
5
Prob-
lem
Rem-
(A,
2
edy
5
Prob-
lem
Rem-
edy
Setting-up operation
No indicator light
on remote control
when pressing "ON"
or "OFF"
· Check if the battery is
inserted correctly.
· Check if the battery has
good contact, if necessary
press down
No reaction from
consumer
· Assign a new code to the
wireless socket (see "Set-
ting up the wireless socket").
· Check - by walking closer to
it - that the range is correct
for the desired location.
Range is too small
· For large ranges, ensure
that as few walls and as
little furniture as possible
are in the way of the
remote control and the
radio-controlled socket.
· If the range is too small
at times, the reason could
be a remote control which
works on a similar fre-
quency. Whenever this re-
mote control is active, the
range declines (e.g. wire-
less headphones, radio-
controlled movement
alarms, radio gongs
etc.).
1
GB
11
Hide quick links:
Advertisement
Chapters
Table of Contents
Need help?
Do you have a question about the WIRELESS SOCKET SET and is the answer not in the manual?
Questions and answers
I have two sockets beside each other. They both light up when I press A
Both sockets in the Silvercrest Wireless Socket Set light up when you press "A" because they are likely assigned to the same channel (A) on the remote control. To control them independently, you need to reassign one of the sockets to a different channel (e.g., B, C, or D) using the setup instructions in the manual.
This answer is automatically generated