Advertisement
Installation and mounting manual for EK-FC Radeon Vega Strix Backplate
This product is intended for installation only by expert users. Please consult with a qualified technician for installation. Improper installation may result in damage to your equipment. EK Water Blocks assumes no liability
whatsoever, expressed or implied, for the use of these products, nor their installation. The following instructions are subject to change without notice. Please visit our web site at
of this product please read important notice, disclosure and warranty conditions printed on the back of the box.
STEP 1: GENERAL INFORMATION. Sample picture of ASUS Radeon ROG RX Vega 64 STRIX 8GB
STEP 2: PREPARING YOUR GRAPHICS CARD
EK-FC Radeon Vega Strix Backplate is very easy to install. First install EK-FC Radeon Vega Strix series water block according to its installation manual. If you
have it already installed, please check the picture below to see which mounting screws are to be left in their position and which are to be removed. Please
remove the six (6) M2.5x4 AX1 screws and their PVC washers as well (marked with arrow).
STEP 3: APPLYING THE THERMAL PADS
EK-FC Radeon Vega Strix Backplate features passive cooling of the printed circuit board and its components therefore it is mandatory to install the
enclosed thermal pad. Please install enclosed 1mm thick thermal pad (Thermal Pad G – 1,0mm (120x24)) as shown on the picture below. You may
need to trim the excess thermal pad.
All disclosures, notices and warranty conditions are being written on the back of the box.
EK-FC Radeon Vega Strix Backplate
BAG CONTENT: Bag content is universal for multiple EKWB
Backplates. You may not need all screws.
Thermal PAD G - 1mm (120x24mm)
Revision 1.0. Released on 12
www.ekwb.com
for updates. Before installation
th
of February, 2018.
Advertisement
Table of Contents
Related Manuals for ekwb EK-FC Radeon Vega Strix Backplate
Summary of Contents for ekwb EK-FC Radeon Vega Strix Backplate
- Page 1 STEP 2: PREPARING YOUR GRAPHICS CARD EK-FC Radeon Vega Strix Backplate is very easy to install. First install EK-FC Radeon Vega Strix series water block according to its installation manual. If you have it already installed, please check the picture below to see which mounting screws are to be left in their position and which are to be removed. Please remove the six (6) M2.5x4 AX1 screws and their PVC washers as well (marked with arrow).
- Page 2 EK blocks are sealed with warranty void circular label, which proves that the block has withstood a pressure leak test. Removing it will void leak-free guarantee and not the guarantee on the product itself. Any other RMA issues can be reported to EK Support at http://www.ekwb.com/support for further analysis.
Need help?
Do you have a question about the EK-FC Radeon Vega Strix Backplate and is the answer not in the manual?
Questions and answers