Configure Alarm - ZKTeco X6 Configuration Manual

DELETE SINGLE USER
Delete a single user Press **++*#+→Press admin fingerprint →press *3+ →Press *2+ → Put work number *#+ /
fingerprint / card →press **+ to exit  Delete all of the users
DELETE ALL USER
Press **++*#+→Press admin fingerprint →press *9++*#+→press **+ to exit
DOOR UNLOCK DURATION
Default: 6 second
Press **++*#+→Press admin fingerprint→press *4+ →Input unlock duration (1s~10s) →press **+ to exit
CONFIGURE ATHENTICATION MODE (FP/PW/RF)
Press **++*#+→Press admin fingerprint →press *5+ →Input authentication mode value *#+→press **+ to exit

CONFIGURE ALARM

Alarm Switch (Default ON) The switch is the master switch of the machine, only when it's on, can the alarm
incorrectly, tamper alarm and magnet alarm be working properly. The alarm will be shut down when it's
off. Press **++*#+→Press admin fingerprint→press *0++ *1+→Configure main switch *#+ (0: ON,
1:OFF)→press **+ to exit
TAMPER ALARM CONFIGURE (Default ON)
Only when this function is on, the machine can be alarmed during tampering. Press **++*#+→Press admin
fingerprint→press *7+→Configure tamper alarm switch *#+ (0: ON, 1:OFF)→press **+ to exit
Buttons represent:
Lights represent:
Number:
Tones:
Mode
PW
RF
FP
FP/PW/RF
RF& PW
FP & PW
[#] means yes, [*] means Escape
Green means success, Red means Failure
Password=4 digits, work code<=5 digits
Long buzz means success, short buzz twice means failure, short buzz 4 times means
wrong action Notice: make sure you pressed [#] to confirm, [*] exit
Value Description
1 Only Password
2 Only Card
3 Only fingerprint
4 Fingerprint or password or card
5 Card then password
6 Fingerprint them password