Set Up The Example Projects On Psoc 5Lp Kit (Cy8Ckit-050) - Cypress CY8CKIT-035 Manual

Figure 3-17. PSoC 3 Kit (CY8CKIT-030) with Power Supervision EBK Connected to Port E
3.3.3

Set Up the Example Projects on PSoC 5LP Kit (CY8CKIT-050)

Set up the PSoC 5LP Kit according to instructions in
1. If this is the first time that the example project firmware is being programmed into PSoC, make
sure the Power Supervision EBK is not connected to the PSoC 5LP Kit.
2. Attach a USB cable from the PC to PSoC 5LP Kit Program/Debug USB port (use J1 - the USB
connector closest to the corner of the board).
3. In PSoC Creator, select the desired example project from the CY8CKIT-050_Examples work-
space. Set the example project as active by right-clicking on it in the Workspace Explorer and
selecting Set as Active Project.
4. In PSoC Creator, select Debug > Program to program PSoC.
5. Remove the USB cable from the PSoC 5LP Kit and attach the Power Supervision EBK to port E
of the PSoC 5LP Kit.
6. On the Power Supervision EBK board, make sure the power jumper (J5) is set to EXT (position 1-
2). Note that this is not the default setting for the J5 jumper. Populate all other jumpers (J6, J7,
J8, J9, J10, J11, J12, and J13).
7. Apply 12-V DC power to the Power Supervision EBK.
8. With the Example Project 1 (Advanced Sequencer) set up properly, all four green LEDs on the
Power Supervision EBK should be turned on and the LCD should show the following.
3. PSoC Creator will generate a few notes during the project build. These notes will not affect the functionality of the project. The notes are
generated due to the Voltage Fault Detector analog routing constraints.
CY8CKIT-035 PSoC® 3 and PSoC 5LP Power Supervision EBK Guide, Doc. #: 001-86225 Rev. *B
PSoC 5LP (CY8CKIT-050) Kit on page
3
Kit Operation
13.
20