Table of Contents
Advertisement
3
Confirm "MENU:OK" is displayed, and then push
the menu lever.
The unit starts printing the current menu settings.
4
Shift the menu lever to the left.
"READY" is displayed and the unit enters the
normal printing mode.
Printing
Before starting a print job, always check the following
points:
• Unit connected correctly? (page 11)
• Printer driver installed? (page 11)
• Paper loaded correctly? (page 13)
• Menu settings and adjustments done correctly?
(page 16)
Starting a Print Job
1
Press the 1 On/standby switch to on.
The back light on the 1 On/standby switch and
LCD lights in green, and "READY" is displayed on
the LCD.
LCD
2
Execute the print job with the software application.
When the message is displayed on the LCD
If a problem occurs, the back light on the LCD lights in
orange and the error message stating the problem is
displayed on the LCD.
Message
Cause and remedy
EMPTY:XX
Paper is not loaded. Load paper.
DOOR:XX
The door is open. Close the door.
XX indicates the selected paper type.
"S" means UPP-110S, "HD" means UPP-110HD, and
"HG" means UPP-110HG.
When the unit stops printing
When printing almost black images continuously, the
thermal head protection circuit may shut down the unit
to prevent the thermal head from overheating. In such a
case, the message "COOLING" is displayed on the
LCD.
Leave the unit until the head cools down and this
message disappears.
22
Hide quick links:
Advertisement
Table of Contents
