Filling The Bag; Vacuum-Packing And Sealing The Bag - Silvercrest SVEB 160 A1 Operating Instructions Manual

4. Open the lid 17.
5. Place the vacuum bagging tube in the
vacuum sealer on the front edge of the
lower sealing ring 14 as shown.
6. Ensure that there are no creases in the
film bag - especially above the welding
wire 15.
7. Close the lid 17 and press it down
slightly.
8. Press the button
vice to standby. The LED is lit.
9. Press the button
up, the pump runs, the lid is sucked in
and the film is sealed. The sealing pro-
cess is automatically terminated and the
LED goes out.
10. Open the lid 17 and remove the bag.
11. Check the welding seam. It should be a
smooth creaseless seam.
30 GB
1 to switch the de-
6. The LED lights
9.3

Filling the bag

CAUTION:
No food or liquids must be present at
the top edge, where you want to seal
the bag. That area must be clean and
dry. Otherwise, it is impossible to pro-
duce a proper welding seam.
• Only fill the bag to approx 7 to 8 cm
below the top edge.
9.4 Vacuum-packing and
sealing the bag
DANGER! Risk of electric
shock due to moisture!
For vacuum-packing, no liquids must be
inside the bag.
Ensure that no liquid is sucked in during
the extraction of air. If this occurs, inter-
rupt the process immediately by press-
ing the stop button
DANGER! Risk of injury from
burning!
The welding wire 15 becomes very hot
during operation. Do not touch the hot
welding wire 15.
NOTE: when vacuum-packing film bags,
there must not be any vacuum tube 20
plugged into the connection 9.
1. Smooth the bag where it is to be
sealed.
2. Open the lid 17.
8.