Extron electronics DTP HDMI 230 Series Setup Manual

DTP HDMI 230 • Setup Guide
This guide provides quick start instructions for an experienced installer to set up and operate the Extron DTP HDMI 230 digital video
extender. The DTP HDMI 230 transmitter and receiver pair can extend an HDCP-compliant HDMI signal up to 230 feet (70 m).
Installation
Step 1 — Mounting
Turn off or disconnect all equipment power sources and mount the Tx and Rx units as required.
DTP HDMI 230 Tx Rear Panel
INPUTS
POWER
AUDIO
12V
0.7A MAX
7 2
Step 2 — Connections
a
HDMI Input connector (Tx) — Connect an HDMI cable
between this port and the HDMI output port of the digital
video source.
NOTE:
See the "
securely fasten the input HDMI connector to the transmitter.
b
Audio input (Tx) — Connect an unbalanced stereo audio source to this 3.5 mm mini
stereo jack for an analog audio input.
c
RS-232 and IR connectors — To pass serial or infrared data or control signals, such as
serial control of a projector, connect the primary device to the transmitter and the secondary
device to the receiver via the RS-232 and IR captive screw connectors on both units.
d
DTP RJ-45 connectors — Connect transmitter DTP Out to receiver DTP In.
Extron recommends that you terminate both cable ends in accordance with the following
specifications, at a minimum:
•
TIA/EIA T 568 B
ATTENTION:
• Do not connect these devices to a computer data or telecommunications network.
• Ne connectez pas ces appareils à un réseau de télécommunications ou de données
informatiques..
Signal LED — Lights when the unit is receiving a TMDS clock signal on the HDMI input (transmitter) or
any valid signal on the DTP In connector (receiver).
Link LED — Lights when a valid link is established between the units on the DTP cable.
e
HDMI Output connector (Rx) — Connect a display with an HDMI input for display of the
transmitted direct digital image.
NOTE:
See the "
the output HDMI connector to the receiver.
SIG LINK OVER DTP
RS-232
Tx Rx
DTP OUT
1 4
LockIt™ Lacing Brackets
•
CAT 6A, shielded
LockIt™ Lacing Brackets
DTP HDMI 230 Rx Rear Panel
POWER
12V
IR
0.7A MAX
G Tx Rx
3 7
INPUTS
AUDIO
" on the back of this guide for to
•
2 4 AWG, solid conductor
"on the back of this guide for to securely fasten
SIG LINK
DTP IN
4 5
Front Panel
OVER DTP
RS-232 IR
Tx Rx G Tx Rx
3
Connected RS-232
Tx/Rx
and IR Device Pins
Pins
Pins:
12345678
TP Wires
OUTPUTS
AUDIO
L R
6
DTP HDMI 230 Rx
Transmit pin on connected unit
Receive pin on connected unit
Ground
Transmit pin on connected unit
Receive pin on connected unit
TIA/EIA T568B
Pin Wire color
1 White-orange
2 Orange
3 White-green
4 Blue
5 White-blue
Green
6
7 White-brown
8 Brown
OUTPUTS
AUDIO
L R
1