Loading The Batteries - Canon 8x20 IS Instructions Manual

Loading the Batteries

The binoculars are equipped with the Image Stabilizer that uses one
CR123A lithium battery.
Be sure not to use batteries with a nominal voltage rating of 3.0V or
z
higher or batteries which have no nominal voltage.
Surface fasteners
ENG-7
1
Open the cover.
Open the battery chamber cover.
z
2
Insert the battery.
Release the surface fasteners and open
z
them out to the left and right.
Load the battery in the correct [+] [–]
z
orientation as indicated at the bottom of
the battery chamber.
When loading the battery, insert the [–]
z
pole against the spring electrode inside
the battery chamber, and then push it in
as far as it will go.
3
Fix the battery firmly in place
with the surface fasteners.
Wrap the surface fastener shown on
z
the left in the illustration around the
battery, and then wrap the right-hand
surface fastener around the battery
from above to fix it firmly in place.
Check to make sure that the surface
fasteners are not loose.
Once the battery is in place, firmly
z
close the battery chamber cover.