Related Manuals for Clarke HIPPO 2
Summary of Contents for Clarke HIPPO 2
- Page 1 SUBMERSIBLE PUMP MODEL NO: HIPPO 2/2A PART NO: 7230023, 7230024 & 7230025 OPERATION & MAINTENANCE INSTRUCTIONS ORIGINAL INSTRUCTIONS GC0120 - rev 5...
-
Page 2: Specifications
Thank you for purchasing this CLARKE Hippo submersible pump. Hippo 2 has the same specification as the Hippo 2A but without a float switch. The Hippo 2 can be supplied for either 110V (part No 7230023) or 230V (part No 7230024) power supplies. -
Page 3: Safety Instructions
SAFETY INSTRUCTIONS GENERAL PUMP SPECIFIC 1. Read all instructions before use 1. Do not pump explosive / and save these instructions for flammable liquids or chemicals. future use. 2. Never allow the pump to run dry 2. An approved residual current or operate out of the water. - Page 4 ELECTRICAL CONNECTIONS - 230V UNITS WARNING: READ THESE ELECTRICAL SAFETY INSTRUCTIONS THOROUGHLY BEFORE CONNECTING THE PRODUCT TO THE MAINS SUPPLY. Connect the mains lead to a standard, 230 Volt (50Hz) electrical supply through an approved 13 amp BS 1363 plug, or a suitably fused isolator switch. If the plug has to be changed because it is not suitable for your socket, or because of damage, it must be removed and a replacement fitted, following the wiring instructions shown below.
- Page 5 ELECTRICAL CONNECTIONS -110V UNITS HIPPO 2 - 110 VOLT UNITS This product can be connected to one of the following power supplies: • 110V generator • 110V isolating transformer • 110V site supply • 230V generator via a 110V transformer.
- Page 6 • Always use a high sensitivity residual current device (RCD) which has a tripping current of less then 30 mA. • The Hippo 2 is designed for use with clean fresh water. Avoid using your pump with salt water or with water containing chemicals as these can cause damage to the pump.
-
Page 7: Maintenance
This pump should require no maintenance other than regular cleaning. If the pump starts to show signs of wear or damage contact the Clarke service department for advice. Do not use the pump if there is any damage to the mains supply cable. -
Page 8: Environmental Recycling Policy
If using this pump in a garden pond, please note that there is a small quantity of oil in the pump seal. If the pump or seal is damaged, the oil may leak out, and appear as a film on the surface of the water. Although harmless to people, the oil must be cleared to prevent any possible harm to pond life. -
Page 9: Troubleshooting
6. Water level is below the minimum level required by the float switch. 7. If the pump still fails to start, consult your CLARKE dealer for advice. PUMP WILL 1. Check that the inlet is not blocked. -
Page 10: Parts List And Diagram
PARTS LIST & DIAGRAM Base 72000940 Mud-pack 72000941 Cable with connector 72000942 Impeller (screw fit to shaft 72000943 Gasket 72000944 Screen/filter 72000945 1/2” adaptor 72000946 3/4” adaptor 72000947 1” adaptor 72000948 Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com... -
Page 11: Declaration Of Conformity
DECLARATION OF CONFORMITY Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com...
Need help?
Do you have a question about the HIPPO 2 and is the answer not in the manual?
Questions and answers