Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Zanussi ZU 9100 F
Summary of Contents for Zanussi ZU 9100 F
- Page 1 FREEZER ZU 9100 F INSTRUCTION BOOKLET 2222740-41...
-
Page 2: Table Of Contents
CONTENTS Instructions for the User Important Safety Instructions Description of the Appliance Operation Before use Freezer controls Starting your appliance Temperature control Warning light (red) Temperature acoustic alarm Open door acoustic alarm Freezing fresh food Frozen food storage Internal thermometer Thawing Ice making Health and... -
Page 3: Important Safety Instructions
Repairs carried out by inexperienced persons may cause injury or serious malfunctioning. Contact your local Zanussi Service Force Centre. At the end of the Appliance Life When disposing of your appliance use an autho- rised disposal site. -
Page 4: Description Of The Appliance
DESCRIPTION OF THE APPLIANCE Freezer calendar Freezer control Compartment for frozen food storage Compartment for freezing fresh food Thermometer OPERATION Before use Remove all securing tapes. Wash inside the appliance with lukewarm water and bicarbonate of soda (5 ml to 0.5 litre of water). Do not use soap or deter- gent as the smell may linger. -
Page 5: Starting Your Appliance
Starting your appliance Insert the plug into the wall socket. The appliance can be activated/deactivated by pressing the ON/OFF button.When the pilot light this shows that the appliance is on. Temperature control The temperature within the freezer is controlled by the thermostat situated at the bottom of the cabi- net . -
Page 6: Internal Thermometer
Internal thermometer This indicates the internal temperature of the freez- er. It may indicate a temperature above -18°C when large quantities of food are placed inside for freezing or when the door is left open for a long time. Thawing Frozen food, prior to being used, can be thawed in the fridge or at room temperature depending on the time available. -
Page 7: Defrosting
DEFROSTING The freezer compartment will become progressively covered with frost. This should be removed with the special plastic scraper provided, whenever the thick- ness of the frost exceeds 1/4". During this operation it is not necessary to switch off the power supply or to remove the foodstuffs. However, when the ice becomes very thick on the inner liner, complete defrosting should be carried out and it is advisable to carry out this operation when... -
Page 8: Maintenance And Cleaning
MAINTENANCE AND CLEANING Before any maintenance or cleaning work is carried out, DISCONNECT the appliance from the ELEC- TRICITY supply. Warning This appliance contains hydrocarbons in its cooling unit maintenance and recharging must therefore only be carried out by authorised technicians. -
Page 9: Something Not Working
SOMETHING NOT WORKING? Before contacting your local Service Force Centre check the following points. IMPORTANT: If you call out an engineer to a fault listed below, or to repair a fault caused by incorrect use or installation, a charge will be made even if the appliance is under guarantee. Symptom No power to the appliance The temperature in the freezer is too high... -
Page 10: Service And Spare Parts
Customer Care Book. CUSTOMER CARE DEPARTMENT For general enquiries concerning your Zanussi appliance or for further information on Zanussi products, you are invited to contact our Customer Care Department by letter or telephone or visit our website at www.zanussi.co.uk... -
Page 11: Guarantee Conditions
Standard guarantee conditions We, Zanussi, undertake that if within 24 months of the date of purchase this Zanussi appliance or any part there- of is proved to be defective by reason only of faulty workmanship or materials, we will, at our option repair or replace the same FREE OF CHARGE for labour, materials or carriage on condition that: The appliance has been correctly installed and used only on the electricity supply stated on the rating plate. -
Page 12: Technical Specifications
TECHNICAL SPECIFICATIONS DIMENSIONS POWER SUPPLY VOLTAGE AND FREQUENCY TOTAL POWER ABSORBED AVERAGE DAILY UNITS ELECTRICITY(*) GROSS CAPACITY NET CAPACITY STAR RATING (*)This figure is based on standard test results in accordance with European Standard EN153. Actual con- sumption will depend on how the appliance is used and where it is located. INSTALLATION Positioning For this appliance to work efficiently, it should be... -
Page 13: Electrical Connection
The cover/carrier is indicated by the coloured insert at the base of the plug. A replacement cover/carrier must be obtained from your local Zanussi Service Force Centre whose address is listed in the Customer Care Booklet which accompanies your instruction manual. -
Page 14: Building-In Instructions
BUILDING-IN INSTRUCTIONS Before carrying out any work, remove the plug from the power socket. Door Reversal Left door opening: 1. Remove the grid from the appliance pulling it towards you with hands. 2. Remove the left side (A) of the grid cutting it from the rear (see figure). - Page 15 To reverse the opening direction of the door, proceed as shown in the figures: Attention After completion of the door reversing opera- tion, check that the door gasket adheres to the cabinet. If the ambient temperature is cold (i.e. in Winter), the gasket may not fit perfectly to the cabinet.
-
Page 16: Building The Appliance In Under A Worktop
Building the appliance in under a worktop The dimensions of the recessed installation area must correspond with those indicated in the figure. DO013 Remove covering and adjusting strips. Push the appliance into place. The plug socket neces- sary for connection of the appliance to the electricity supply should be positioned, so that the plug is not placed in the recess. - Page 17 To mount the furniture door proceed as shown in the figures:...
- Page 18 Screw appliance into place. Refit the covering strip.
-
Page 19: Fitting The Plinth
Fitting the plinth Important For the efficient operation of the appliance, it is important that the original ventilation grid is used. For an opening height dimension A=820 mm and a plinth height dimension a=100 mm, the plinth may be fitted without adjustments. The same applies to an opening height dimension B=870 mm and a plinth height dimension b=150 mm. - Page 20 © Electrolux Household Appliances Limited 2000...