Enable Or Disable A Device; Enable Or Disable The Configuration Change Detection Feature - Lenovo ThinkSmart Hub User Manual

• If the storage device is internal, go to step 2.
• If the storage device is a disc, ensure that the hub is on or turn on the hub. Then, insert the disc into
the optical drive.
• If the storage device is an external device other than a disc, connect the storage device to the hub.
2. Restart the hub. When the logo screen is displayed, press F1 or Fn+F1.
3. Select Startup, and then follow the on-screen instructions to change the startup sequence.
4. Press F10 or Fn+F10 to save the changes and exit.
Select a temporary startup device
Note: Not all discs and storage drives are bootable.
1. Depending on the type of the storage device, do one of the following:
• If the storage device is internal, go to step 2.
• If the storage device is a disc, ensure that the hub is on or turn on the hub. Then, insert the disc into
the optical drive.
• If the storage device is an external device other than a disc, connect the storage device to the hub.
2. Restart the hub. When the logo screen is displayed, press F1 or Fn+F1.
3. Select the storage device as desired and press Enter.
If you want to change the startup device sequence permanently, select Enter Setup on Startup Device Menu
and press Enter to enter the BIOS menu.

Enable or disable a device

This section provides information about how to enable or disable user access to hardware devices (such as
USB connectors or storage drives).
To enable or disable a device, do the following:
1. Restart the hub. When the logo screen is displayed, press F1 or Fn+F1.
2. Select Devices.
3. Select the device you want to enable or disable and press Enter.
4. Select the desired setting and press Enter.
5. Press F10 or Fn+F10 to save the changes and exit.

Enable or disable the configuration change detection feature

If you enable configuration change detection, when the POST detects configuration changes of some
hardware devices (such as storage drives or memory modules), an error message will be displayed when you
turn on the hub.
To enable or disable the configuration change detection feature:
1. Restart the hub. When the logo screen is displayed, press F1 or Fn+F1.
2. Select Security ➙ Configuration Change Detection.
3. Enable or disable the feature as desired.
4. Press F10 or Fn+F10 to save the changes and exit.
To bypass the error message and log in to the operating system, press F2 or Fn+F2. To clear the error
message, enter the BIOS menu, save and then exit.
16
ThinkSmart Hub User Guide