Sharp AN-LS1 Operation Manual page 50

\ Check if the "TCP/IP" protocol is operating correctly using the "PING" command. Also, check if an
Downloaded from: http://www.usersmanualguide.com/
IP address is set.
1. Open a command prompt (MS-DOS Prompt).
• In the case of Windows 98 or 98SE: click "START" → "Programs" → "MS-DOS Prompt" in
order.
• In the case of Windows Me: click "START" → "Programs" → "Accessories" → "MS-DOS
Prompt" in order.
• In the case of Windows 2000: click "START" → "Programs" → "Accessories" → "Command
Prompt" in order.
• In case of Windows XP: click "START" → "Programs" → "Accessories" → "Command Prompt"
in order.
2. After launching the command prompt (MS-DOS Prompt) enter a command "PING".
Entry example C:\>Ping XXX.XXX.XXX.XXX
"XXX.XXX.XXX.XXX" should be entered with an IP address to be connected to, such as AN-
LS1.
3. When connecting normally, the display will be as follows.
(The screen may be slightly different depending on the OS type).
<Example> when the IP address connected to is "192.168.150.2"
4. When a command cannot be sent, "Request time out" will be displayed.
Check the network setting again.
If communication can still not be established properly, contact your network administrator.
5. To return to the Windows screen, enter "exit" and then press the "RETURN" key.
50