Zanussi 136905611-00-02092008 User Manual page 17

Malfunction
When pressing a button,
the corresponding
button flashes several
times.
Drying cycle ends
shortly after programme
starts. END
light illuminated.
Programme inactive,
Condenser
light illuminated.
Drying cycle lasts an
unusually long time.
Note:
After around 5 hours
the drying cycle ends
automatically (see
„Drying cycle complete")
I
f you are unable to identify or solve the
problem, contact your local Service Centre.
Before telephoning, make a note of the
model, serial number and purchase date of
your machine: the Service Centre will
require this information.
Possible cause
•
Washing protection.
After the start of the pro-
gramme, the option can no
longer be set.
•
Not enough washing
loaded
or washing loaded is too
dry for selected programme.
•
Water reservoir is full.
•
Lint filter clogged.
•
Heat exchanger clogged
with lint.
•
DELICATE button pressed
and load volume too big.
•
Load volume too big.
•
Laundry insufficiently
predrained.
•
Turn the programme knob to
OFF. Set the programme again
•
Select time programme or
higher drying level (e.g.
EXTRA DRY instead of CUP-
BOARD).
•
Empty the water reservoir,
then start programme with
START/PAUSE button.
•
Clean lint filter
•
Clean heat exchanger.
•
DELICATE is only suitable for
use with loads of up to 3 kg!
•
Reduce load volume.
•
Laundry must be adequately
pre-drained.
Important:
If you call out an engineer to a fault listed
below, or to repair a fault caused by
incorrect use or installation, a charge will be
made even if the appliance is under
guarantee.
Solution
17