Table of Contents
Advertisement
A
4
Counterweight
guide rail
a 210
Alimak original dia. 76 mm
pivoted tube coupler
Hoist mast
The square mast c/c 650 x 650 mm (2'- 1 1/8'' x 2'- 1 1/8'') is
the mainstay of the SCANDO 650 access system. The mast is
constructed of tubes and frames of high tensile steel and
fabricated in lenghts of 1508 mm (4'- 11 3/8''). Each section is
provided with one or two bolted rack(s) module 5 and the
sections are bolted together with bolts and nuts.
The four guiding tubes and possibilities with two racks give
dual car set up advantages. Counterweight guide rail can be
bolted to all mast sections.
The ties are attached to the frames of the mast sections or alt. to
the rear mast tubes. The other end to special brackets attached
to the wall. The tie length is telescopic adjustable within
different intervals. The ties can also be inclined from the
horizontal. Specifications for each particular mast tie can be
found in chapter H.
Mast sections and mast ties are hot dipped galvanized with the
exception of the mast section rack.
... or against wall
Wall bracket bolt dimension is M24
ALIMAK 34742 - 1/02
Corresponding wall
bracket can be installed
either on slab ...
Hide quick links:
Advertisement
Chapters
Table of Contents
Need help?
Do you have a question about the Scando 650 Series and is the answer not in the manual?
Questions and answers
Не поднимается, что делать?
If the Alimak Scando 650 Series does not lift when starting in the Up direction, follow these steps:
1. Check if the contactors oscillate on and off ("shatter") when starting with a full load.
2. Inspect the contacts of the Up and main contactors for damage.
3. Measure the incoming power supply voltage at both the B-panel at the base and the M-panel in the car during starting conditions with a rated load.
4. Determine if the voltage drop exceeds acceptable values.
5. If a voltage drop issue is identified, increase the conductor size in the power supply cable from the job site distribution.
These steps help diagnose and resolve voltage drop problems affecting the hoist's operation.
This answer is automatically generated