Display Codes - Delem DAC-360 Installation Manual

4.4.

Display codes

In the upper richt corner of the screen, a status code is shown that indicates the current status
of the control. Such a code can either be a status code or and error code.
The following table shows the possible status codes:
S0 Stopped
S1 Positioning
S2 Wait for ST low
S3 Wait for EOS
S4 Wait for UDP
S5 Wait for STEP high
S6 Wait for end of retract Waiting for end of retract when STEP is already high.
S7 Wait for safe X
The following table shows the possible error codes:
E1.. Internal error (1)
E21 Power supply failure
E23 Encoder 1 error
E24 Encoder 2 error
E53 Invalid parameters
E56 No movement on X-axis
E57 No movement on A-axis
E58 No movement on G1-axis
E59 No movement on G2-axis
E94 Internal error (1)
(1) If this error occurs, reboot the control. If the error persists, contact your machine supplier.
Waiting for the operator to press start while pump start is
high
Not all axes are in position yet
Waiting for STEP input falling edge
Wait for EOS, generated by potentiometer or BR
Wait for UDP, generated by potentiometer or STEP input
Waiting for STEP input rising edge
Waiting until X-axis is in safe area
Delem
V0208, 2.49