Maintenance; Parts Diagram; Parts List - JobSmart 3951103 Assembly & Operating Instructions

Insert your hands into the gloves. Be certain your fingers are properly positioned and you can move your
hands easily and grip the work piece comfortably.
Point the nozzle and operate the gun to be certain that the blaster is working correctly. Make certain there
is no leaks.
Hold the work piece, and position your fingers so that the glove is not in the way of the work piece. Reposition
the work piece as needed in order to access the complete surface area.
Use a circular motion or side-to-side motion, and the nozzle should be 2 inches away from the work piece.
Once the work piece is completed, remove your hands from the gloves and turn the blaster and compressor off.
Dirt and water in the air supply are major causes of pneumatic tool wear. Use a filter/oiler for better performance
and longer life of the tool. The filler must have adequate flow capacity of r the specific application.

MAINTENANCE

Keep your abrasive blaster clean, and protect it from damage .
Check for damaged parts before and after use. Replace any parts which appear worn. Call customer service
for replacement parts if needed.

PARTS DIAGRAM

PARTS LIST

Part # Description
SBC901 Grid
SBC902 Fluorescent Tube 12V
SBC903 End Connector
SBC904 Plastic Cover
SBC905 Input Cable Assembly
SBC906 Cable Gland Assembly
SBC907 Power Cable Assembly
3951103 JobSmart Abrasive Blast Cabinet Assembly & Operating Instructions 7