Auto Punch In/Out Recording
This section explains how to perform auto punch in/out recording for real. With the
Auto Input monitoring function turned on, playback and input monitor switching is
performed automatically at the LAST REC IN and OUT points. See "Monitoring" on
page 42 for more information.
The following illustration shows the procedure for auto punch-in/out recording.
1-1
2-1
READY
2
3-1
4-1
5-1
6-1
7-1
8-1
AUTO
2
PUNCH
RECORD
READY
Set the LAST REC IN and OUT points. See "Setting the LAST REC IN & OUT
1
Points" on page 71 for more information.
Use the [RECORD READY] buttons to select tracks for recording.
2
The corresponding READY indicators flash.
Press the [AUTO PUNCH] button.
3
The AUTO PUNCH indicator flashes and the following display appears.
Press the [REC] and [PLAY] buttons simultaneously.
4
The PLAY button indicator lights up and the REC indicator flashes. The Pre-roll point
is located, and then playback starts. The Pre-roll time is set using the Pre Roll function.
See "Setting the Pre-roll Time" on page 76 for more information.
Record punch in is performed automatically at the LAST REC IN point.
5
The READY and REC button indicators light up continuously.
Record punch out is performed automatically at the LAST REC OUT point.
6
The REC button indicator goes out and the READY indicators flash
Playback continues up to the Post-roll point at which playback stops, the PLAY button
indicator goes out, the Pre-roll point is located, and the D24 waits. The display shows
"AUTO PUNCH—REC TAKE 2".
Pre-roll
LAST REC IN
point
1
2
3
4
5
6
7
8
Locate
Play
PLAY
REC
Auto Punch In/Out Recording
LAST REC OUT
point
point
Record
73
Post-roll
point
Play
D24—Owner's Manual