Mercury+ Pe1 Base Board; Xilinx Tool Support - Enclustra Mercury XU5 User Manual

1.4.3

Mercury+ PE1 Base Board

168-pin Hirose FX10 module connectors (PE1-200: 2 connectors; PE1-300/400: 3 connectors)
System controller
Power control
System monitor (PE1-300/400)
Current sense (PE1-300/400)
Low-jitter clock generator (PE1-300/400)
Accelerometer/magnetometer/temperature sensor (PE1-300/400)
microSD card holder
User EEPROM
eMMC managed NAND flash (PE1-300/400)
PCIe 4 interface
USB 3.0 device connector
USB 2.0 host connector (PE1-200: 1 connector; PE1-300/400: 4 connectors)
Micro USB 2.0 device (UART, SPI, I2C, JTAG) connector
2 RJ45 Gigabit Ethernet connectors
mPCIe/mSATA card holder (USB only) (PE1-300/400)
SIM card holder (optional, PE1-300/400 only)
SMA clock and data in/out (optional, PE1-300/400 only)
1 FMC LPC connector (PE1-200)
1 FMC HPC connector (PE1-300)
2 FMC LPC connector (PE1-400)
2 40-pin Anios pin header
3 12-pin Pmod™ pin header
5 to 15 V DC supply voltage
USB bus power (with restrictions)
Please note that the available features depend on the equipped Mercury module type and on the selected
base board variant.
1.5

Xilinx Tool Support

The MPSoC devices equipped on the Mercury XU5 SoC module are supported by the Vivado HL WebPACK
Edition software, which is available free of charge. Please contact Xilinx for further information.
D-0000-445-001 9 / 64 Version 07, 25.07.2019