Do you have a question about the LITTLE Green PRO and is the answer not in the manual?
Questions and answers
Janis Harris
February 12, 2025
Does stain and spot cleaner need to be rinsed?
1 comments:
Mr. Anderson
February 12, 2025
The Bissell Little Green Pro does not specifically require rinsing after use. It sprays cleaning solution onto stains, scrubs them, and then suctions the solution and debris into a separate dirty water tank. However, for best results, users may choose to rinse the cleaned area with water and suction it up to remove any leftover cleaning solution.
Page 1
Do not plug in your deep cleaner until To reduce the risk of fire and electric shock you are familiar with all instructions and due to internal component damage, use operating procedures. only BISSELL cleaning fluids intended for use with the deep cleaner.
Page 2
Carry Handle 2 Power Button 3 Formula & Clean Water Tank 4 Dirty Water Tank 5 Power Cord 6 QuickRelease™ Cord Wrap 7 Flex Hose 8 6” upholstery tool...
WARNING Improper connection of the equipment-grounding conductor can result in a risk of electrical shock. Check with a qualified electrician or service person if you aren’t sure if the outlet is properly grounded. DO NOT MODIFY THE PLUG. If it will not fit the outlet, have a proper outlet installed by a qualified electri- cian.
Non-BISSELL cleaning solutions may harm the machine. WARNING TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY: » Use only BISSELL cleaning products intended for use in this machine to prevent internal component damage. » Do not use a flammable or combustible liquid.
Page 5
» Do not use with damaged cord or plug. If appliance is not working as it should, has been dropped, damaged, left outdoors or dropped into water, have it repaired at an authorized service center. » Do not pull or carry by cord, use cord as a handle, close a door on cord, or pull cord around sharp edges or corners.
Pretreating is recommended to improve cleaning effectiveness for heavily soiled carpet in high traffic areas such as entryway and hall- ways. b. Stain Pretreat Spray the BISSELL Pretreat formula onto heavy traffic areas, soiled areas or stains. Allow to penetrate for at least 3 minutes.
3. Fill tank with hot tap water to the water fill line. Add two ounces (1/4 cup) of BISSELL formula to the tank. 4. Replace the bottle insert in the tank and tighten the black cap. Replace the tank on the portable machine.
Cleaning with Tools IMPORTANT! If using to clean upholstery, check uphol- stery tags. Check manufacturer’s tag before cleaning. “W” or “WS” on the tag means that you can clean this with a spot cleaner. If the tag is coded with an “X” or an “S”(with a diagonal stripe through it), or says “Dry Clean Only”, do not proceed with any deep cleaning machine.
Page 9
Empty dirty tank 1. Empty the dirty tank when dirty water reaches the “FULL” line on the tank. 2. Remove dirty water tank and carry to a utility sink, toilet, or outside to dispose of dirty water. 3. To unlock the dirty tank lid, rotate handle over the back of the tank.
Cleaning and Storage 1. Remove upholstery tool by pressing the small black button on top and pulling tool away from hose. Rinse tool in clean running water. Reattach tool when dry. 2. Suction clean water to rinse the hose. While machine is still running, lift end of hose and stretch to ensure all water is cleared from hose.
Page 11
WARNING To reduce the risk of electric shock, turn power switch off and disconnect plug from electrical outlet before performing maintenance or trouble- shooting checks. Problem Possible causes Remedies Formula & water tank Refill tank. may be empty. Formula & water tank Turn power OFF.
Need help?
Do you have a question about the LITTLE Green PRO and is the answer not in the manual?
Questions and answers
Does stain and spot cleaner need to be rinsed?
The Bissell Little Green Pro does not specifically require rinsing after use. It sprays cleaning solution onto stains, scrubs them, and then suctions the solution and debris into a separate dirty water tank. However, for best results, users may choose to rinse the cleaned area with water and suction it up to remove any leftover cleaning solution.
This answer is automatically generated