Yamaha Clavinova CLP-100 Owner's Manual page 85

1.
Attach C to D and E.
D
C
1-1
1-2
1-1
Untie and straighten out the bundled pedal cord.
Do not discard the vinyl tie. You will need it later
in step 5.
1-2
Attach D and E to C by tightening four long
screws (6 x 25 mm).
2.
Attach B.
Depending on the model of Clavinova you pur-
chased, the surface color of one side of B may be
different from the other side. In this case, posi-
tion B so that the side of the surface color most
similar to D and E faces you (as you would play
the instrument).
2-1
Place the lower side of B on each foot of D and E,
then align the screw holes on the upper side of B
with the bracket holes on D and E.
2-2
Attach the top corners of B to D and E by finger-
tightening two thin screws (4 x 12 mm).
2-3
While pushing the lower part of D and E from
outside, secure the bottom end of B using four
tapping screws (4 x 20 mm).
2-4
Securely tighten the screws on the top of B that
were attached in Step 2-2.
2-1
E
Place the bot-
tom end of the
rear panel on
each foot.
2-3
E
2-2
2-4
B
D
CLP-340/330: Keyboard Stand Assembly
3.
Mount A.
Be sure to place your hands at least 15 cm from
either end of the main unit when positioning it.
A
15 cm or
further in
15 cm or
further in
CAUTION
Be extra careful not to drop or let your fingers be pinched by the
main unit.
CAUTION
Do not hold the main unit in any position other than the posi-
tion specified above.
4.
Secure A.
4-1
Adjust the position of A so that the left and right
ends of A will project beyond D and E equally (as
seen from the front).
4-2
Secure A by tightening the short screws (6 x 16
mm) from the front.
Projection
of A
CLP-370/340/330, CLP-S308/S306 Owner's Manual
4-1
A
4-2
Insert the screw in the front of
these two holes.
85