Transition Preview - Sony MVS-8000 User Manual

Transition Preview

Carrying out a transition preview
For an overview of the transition preview, see page 42.
1
2
To terminate a transition preview
There are three modes for a transition preview. To terminate a transition
preview, carry out the operation which depends on the mode, and press the
[TRANS PVW] button, turning it off.
Lock: Toggling the [TRANS PVW] button on and off switches between the
Hold: The preview mode obtains only while the [TRANS PVW] button is held
One Time: Each time a transition ends, it reverts to the normal mode.
Set the transition preview mode in the following combinations. For details, see
Chapter 16 "Engineering Setup" (Volume 2).

Transition Preview

mode
Lock
Hold
One Time
Notes
• During a transition, whether executed with the [AUTO TRANS] button or
• In bus fixed mode (see page 41), transition previews are not available.
326
Transition Preview
In the M/E or PGM/PST bank transition control block, press the [TRANS
PVW] button.
The [TRANS PVW] button lights green, and the switcher is now in the
transition preview mode. At this point, the preview output is the same as
the program output before the [TRANS PVW] button was pressed.
Operate the fader lever, or press the [AUTO TRANS] button or [CUT]
button.
On the preview monitor, you can check the effect of the transition.
transition preview mode and the normal mode.
down.
Switcher setup
(Transition menu)
<Transition Preview> group
Normal
Normal
One Time
the fader lever, it is not possible to press the [TRANS PVW] button.
Panel setup
(Operation >Custom Button
menu)
<Trans Pvw> group
Lock
Hold
–