Table of Contents
Advertisement
Digital output
Analog output
Night mode
59
✘ No picture appears on the TV after switching
1 Disconnect the recorder's power cord.
2 Hold down t on the DVD Recorder while reconnecting the power cord.
3 If you want to switch back, repeat steps 1 and 2. "PRO" disappears from the dis-
Sound settings
Depending on which audio outputs are used, you can select the settings in this menu.
If you only use the analogue audio output (AUDIO L, R), select the settings "Off" in
the "Digital output" menu.
"Digital output"
For devices connected to the DIGITAL AUDIO OUT jack, you can select from the
n
following settings.
"All":
Sound
All
Stereo
Off
"PCM only": Dolby Digital and MPEG-2 multi-channel signals are converted to PCM
"Off":
"Analog output"
For devices connected to the analogue audio output (AUDIO L, R), you can select
from the following settings.
"Stereo":
"Surround":
"Night mode"
Night mode optimises the sound for playback at low volume. You are therefore less
likely to disturb your neighbours. This only works for Dolby Digital audio on DVD
video discs.
Check the display of your DVD recorder.
"PRO": "Progressive Scan" is on
No display: "Interlaced" is on. Switch your TV to the corresponding input jack
or select the corresponding connection. You can also switch the Component
video output signal as follows:
"PRO" (progressive scan) appears on the display.
play. The DVD Recorder is switched to "Interlaced."
Unalterned signals of Dolby Digital and DTS are fed to the digital out-
put. MPEG-2 multi-channel signals are converted to PCM (Pulse Code
Modulation).
For receivers/amplifiers with digital multi-channel sound decod-
ers.
(Pulse Code Modulation).
For receivers/amplifiers without digital multi-channel sound
decoders.
Digital output switched off.
For devices with analogue audio input.
For devices without DolbySurround, use this setting if the DVD
recorder is only connected to a stereo TV set.
Dolby Digital and MPEG-2 multi-channel are mixed down to a Dolby
surround-compatible two-channel output signal. For devices with
Dolby Surround Pro Logic decoder.
Problem
User preferences
Advertisement
Table of Contents
