Ethersam - Global X - EXFO MAX-800 Series User Manual

EtherSAM - Global
From the Test menu, tap Setup, Test Configurator, tap on the test block,
and on the Global tab.
Dual Test Set
Dual Test Set (DTS) check box when selected (cleared by default)

enables EtherSAM Dual Test Set. Once Dual Test Set is enabled, use
the Discover Remote button to select a remote unit. Not available in
Dual Port topology.
Note: It is also possible using the Discover Remote button to connect to a remote
unit and automatically enable Dual Test Set. For more details, refer to
Discover Remote Button on page 380.


Note: When there is a NAT at the Remote site, it is required to create UDP/TCP
port 62819 forwarding rule on this NAT router to allow DTS communication.
In addition, when there is a NAT in both directions (L->R and R->L), it is
also required to create port forwarding rules on the NAT router located at
the Remote side for every service defined.
Discover Remote button allows discovering remote unit supporting

Remote Loopback and/or Dual Test Set. For more details, see
Discover Remote Button on page 380.
MaxTester
Test Setup - Test Configurator, Timer, and System
Disconnected indicates that there is no connection established
with a remote unit.
NAT LAN/WAN and WAN IP indicate presence of NAT (Network
Address Translation) router. The NAT router is automatically
detected and graphically displayed with LAN/WAN indication as
well as the WAN IP address when the unit is behind a NAT router.
EtherSAM - Global
99