Chapter 4 Installation And Wiring 4-1 To; Installation Of Module; Loading The Module - Hitachi HIDIC EH-150 Applications Manual

Chapter 4

4.1 Installation of Module

EH-RMP can be installed in 0-2 slot on the basic base unit.
Install and uninstall the module after turn off the base unit power source.

4.2 Loading the Module

(1)Installing
(2)Removing
3)
Installation and Wiring
2)
1)
1)
2)
Chapter 4 Installation and Wiring
1) Hook the claw at the lower section of the
module to the hole in the base.
2) Press in the upper side of the module until
it clicks.
Note 1: After loading the module, check to
make sure it does not come out.
Note 2: Load the power module at the leftmost
side of the base unit.
Note 3: Load the CPU module and I/O
controller to the right neighbor of the
power module.
1) Push in the lock button.
2) With the lock button pushed in, pull the top
of the module toward the front.
3) Raise it toward the top and pull it out.
Note: For the power module, pull it out while
pushing down the two lock buttons.
4- 1