Using The Remote Setup Wizard To Configure The Software - Dell EqualLogic PS Series Installation And Setup Manual

Installation and Setup
Using the Remote Setup Wizard to Configure the
Software
The Remote Setup wizard is located on the Host Integration Tools CD-ROM and
must be installed on a Windows computer. The Host Integration Tools User Guide
provides detailed information about using the full capabilities of the Remote
Setup Wizard.
To run the Remote Setup Wizard, follow these steps:
1. Choose a computer that meets the requirements in Step 1: Choose a
Configuration Method on page 3-1.
2. Obtain the Host Integration Tools CD-ROM from the shipping box.
3. Insert the CD-ROM in the computer and install the Remote Setup Wizard.
4. Start the Remote Setup Wizard by clicking:
Start > Programs > EqualLogic > Remote Setup Wizard
5. In the Welcome dialog box, select
click .
Next
Note: If you cannot contact the array, check the network configuration. You
may need to use the
6. Select the array that you want to initialize and click
7. In the Initialize Array dialog box, enter the array configuration from Table 3-1
and choose to create a group or join an existing group. Then, click
8. In the Create a New Group or Join an Existing Group dialog box, enter the
group configuration from Table 3-2 and click
9. Click
Finish
If you added the array to an existing group, you must set the member's RAID
policy in order to use the disk storage. Go to Step 4: Set the Member RAID Policy
on page 3-8.
If you created a new group, go to Chapter 4, Storage Allocation.
setup
to exit the wizard.
Initialize a PS Series array
utility to configure the software.
Next
.
Next
Software Configuration
and
.
.
Next
3–7