Step 3: Turn On Power To The Array - Dell EqualLogic PS Series Installation And Setup Manual

Installation and Setup Installing a PS6500 Array
Figure 2-18: Recommended Network Configuration - PS6500
Use the cable management system to organize the network cables, along with the
power cables. See Figure 2-12 through Figure 2-16.

Step 3: Turn on Power to the Array

Before turning on power, allow sufficient time for the PS6500 to adjust to ambient
temperature (for example, overnight).
Turning on the power transitions the array from standby mode to full-power
mode.
The power switch is on the front of the array. To turn on power to the array you
must remove the front bezel, as follows:
1. Insert the bezel key and turn it clockwise to unlock the bezel. See Figure 2-19.
2–24