Section.8:.Automatic.failure.detection.system - Matsui M100WM10E Installation And Instruction Manual

SECTION 8: AUTOMATIC FAILURE DETECTION SYSTEM
Your machine is equipped with systems which will both take the necessary precautions and
warn you in case of any failure by controlling itself constantly during the washing processes.
FAILURE CODE
Err 01
Err 02
Err 03
Err 05
Err 06
Err 07
Err 08
Err 09
(*) See the section regarding the maintenance and cleaning of your machine.
M100WM10E_20100209_without PN.indd 23
FAILURE PROBABLE
INDICATOR FAILURE
The start/pause The door is not
light blinks. shut properly.
The programme The water level
ready light blinks. in your machine
may be low. The
pressure of your
water supply
may be low or
blocked.
The start/ The pump has
pause light and failed or the
programme ready pump filter is
light blinks . obstructed.
The start/ The heater of your
pause light and machine or the
programme end heat sensor has
light blink. failed.
The programme The motor has
ready light and failed.
programme end
light blink.
The programme Configuration
start/pause light, error.
ready light and
programme end
light stays on
permanently.
The start/pause The motor has
light, programme failed.
ready light and
programme end
light blink.
The programme The network
ready light and voltage is too
programme end high or too low.
light stays on
permanently.
THE PROCESS TO BE DONE
Shut the door properly so that
you should hear a click. If the
problem persists, turn off the
machine unplug and contact an
authorised technician.
Check that the water supply to
the machine is unobstructed,
check the water tap is fully on.
If the the problem continues,
turn off the machine and contact
an authorised technician.
Clean the pump filter. If the
problem persists, contact an
authorised technician. (*)
Shut down your machine and
unplug. Turn off your tap and
contact an authorised technician.
Shut down your machine and
unplug. Turn off the tap and
contact an authorised technician.
Shut down your machine and
unplug. Turn off the tap and
contact an authorised technician.
Shut down your machine and
unplug. Turn off the tap and
contact an authorised technician.
If the network voltage is lower
than 150V or higher than 260V,
your machine will automatically
stop. When the network voltage
is recovered, your machine will
continue its operation.
GB-23