Download Print this page

Siemens ZIC-2C Installation Instructions

2 channel audio enhancement card for the zic-8b

Advertisement

Quick Links

Installation Instructions
Model ZIC-2C
2 Channel Audio Enhancement Card for the ZIC-8B
INTRODUCTION
INSTALLATION
P/N 315-048671-3
The Model ZIC-2C from Siemens Industry, Inc., adds
support for 2 channel audio to the ZIC-8B card. The
ZIC-2C replaces the signal routing board that is
installed on the ZIC-8B in the factory. The ZIC-2C
mounts in the same location as the signal routing
card and utilizes the same mounting hardware. Three
8 pin headers and one 20 pin header are also reused
with the ZIC-2C.
Remove all system power before installation, first battery then AC. (To power up,
connect the AC first, then the battery.)
1.
If the ZIC-8B is installed in the FireFinder XLS/Desigo Fire Safety Modular/
Cerberus PRO Modular card cage (CC-5/CC-2) remove it now. If you are
using a new ZIC-8B remove it from it's carton.
2.
Remove the signal routing card from the ZIC-8B by removing the screws in
the two mounting standoffs and gently pulling the signal routing card out of
the connectors on the ZIC-8B. Save the screws. The two mounting stand-
offs should remain attached to the ZIC-8B.
3.
Make sure that the three 8 pin headers and one 20 pin header between the
ZIC-8B and the signal routing card remain installed in J4, J5, J10 and J11 of
the ZIC-8B. If these headers stayed with the signal routing card remove
them and re-install them into the ZIC-8B. Check that each header is com-
pletely seated in the receptacles on the ZIC-8B. (Refer to Figure 2.)
4.
Discard the signal routing card.
5.
Being careful to align all of the headers and the mounting standoffs, gently
press the ZIC-2C down until the headers and standoffs fully mate. Check
that all of pins of the headers are inserted into the sockets on the ZIC-2C
and the ZIC-8B. Secure the ZIC-2C by reusing the two screws from Step 2.
6.
Install the ZIC-8B into the card cage ( CC-5/CC-2 ).
Figure 1
ZIC-2C Two Channel Audio
Enhancement Card
Siemens
Siemens Industry
Siemens
Industry
Industry, , , , , Inc.
Siemens
Siemens
Industry
Building
Building
Building
Building
Building T T T T T ec
ec
ec
echnologies Di
ec
hnologies Division
hnologies Di
hnologies Di
hnologies Di
Industry
Inc.
Inc.
Inc.
Inc.
vision
vision
vision
vision

Advertisement

loading

Summary of Contents for Siemens ZIC-2C

  • Page 1 ZIC-2C down until the headers and standoffs fully mate. Check that all of pins of the headers are inserted into the sockets on the ZIC-2C and the ZIC-8B. Secure the ZIC-2C by reusing the two screws from Step 2.
  • Page 2 24V Standby Current Cyber security disclaimer Siemens products and solutions provide security functions to ensure the secure operation of building comfort, fire safety, security management and physical security systems. The security functions on these products and solutions are important components of a comprehensive security concept.