Figure 4.2. View Of The Target Cos Φ Setting; Figure 4.3. View Of The Programmable Parameters; Figure 4.4. View Of The "Feature" Parameters - ABB APC Series Installation, Operation And Maintenance Instructions

7. Setting of the target cos ϕ
Press the Mode button once to activate the manual setting of the target cos ϕ.
The already programmed value is displayed. If the RVC has never been programmed before, "
appears on the LCD display.
Set your target cos ϕ by pressing either the – or + button.
indicates an inductive PF and
8. Reactivate the AUTO Mode by pressing the mode button repeatedly.
During this procedure, the values of the parameters automatically set in the previous step will be
displayed first: Phase, C/k, Delay and Steps.
Then come Feature 1 (linear / circular) and Feature 2 (generative / regenerative target cos ϕ) parameters
on the screen.
Finally Protection 1 (overvoltage - Max Vrms), Protection 2 (undervoltage - Min Vrms) and Protection 3
(over THDV - Max THDV) are displayed.
APC - Chapter 4. Easy commissioning
Figure 4.2. View of the target cos
indicates a capacitive PF.

Figure 4.3. View of the programmable parameters

Figure 4.4. View of the "Feature" parameters

ϕ
setting
"
21