Verify Anti-Tip Bracket Location; Level Range; Electronic Ignition System - Whirlpool W10032070 User Manual

30" (76.2 cm) freestanding gas ranges
Table of Contents

Advertisement

5. Close the broiler door.
6. Remove cooktop burner caps and grates from parts
package. Align notches in burner caps with pins in burner
base. Burner caps should be level when properly positioned.
If burner caps are not properly positioned, surface burners
will not light. Place burners, burner caps and grates on the
cooktop.
WARNING
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
7. Plug into a grounded 3 prong outlet.

Verify Anti-Tip Bracket Location

1. Check that the anti-tip bracket is installed:
Look for the anti-tip bracket securely attached to the floor.
Slide the range back so the rear range foot is under the anti-
tip bracket.

Level Range

1. Place rack in oven.
2. Place level on rack and check levelness of range, first side to
side; then front to back.
3. If range is not level, pull range forward until rear leveling leg is
removed from the anti-tip bracket. Use
wrench or pliers to adjust leveling legs up or down until range
is level.
4. Push range back into position.
5. Check that rear leveling leg is engaged in anti-tip bracket.
NOTE: Range must be level for satisfactory baking performance.
10
Initial lighting and gas flame adjustments
Cooktop and oven burners use electronic igniters in place of
standing pilots. When the cooktop control knob is turned to the
"LITE" position, the system creates a spark to light the burner.
This sparking continues until the control knob is turned to the
desired setting.
When the oven control is turned to the desired setting, a hot
surface igniter heats to a bright orange and ignites the gas. No
sparking occurs. The glow bar remains on while the burner
operates.
Check Operation of Cooktop Burners
1. If control panel and knobs were removed earlier, reinstall
2. Push in and turn each surface unit control knob to the "LITE"
3. Turn control knob to the "HI" position after burner lights.
4. Check each cooktop burner for proper flame. The small inner
5. Turn the control knob quickly to the "LO" position after the
6. Check each cooktop burner for proper low flame. The low
If the low flame needs adjusting:
1. With the burner flame on, turn control knob to the "Lo"
" drive ratchet and

Electronic Ignition System

knobs.
position. The flame should light within 4 seconds.
LIT E
ME D
cone should have a very distinct blue flame ¼" (0.64 cm) to
½" (0.13 cm) long. The outer cone is not as distinct as the
inner cone.
A. Outer cone
B. Inner cone
burner lights. If the flame goes out, turn the control knob to
the "OFF" position.
flame should be a minimum, steady blue flame. The flame
size should be ¼" to
" (0.64 cm to 0.95 cm) high.
setting and remove control knob.
O FF
LO
A
B

Advertisement

Table of Contents
loading

This manual is also suitable for:

Wfg110avWfg111svWfg110avqWfg111svqW10032070b

Table of Contents