Sleep Mode; Making A Call; Receiving A Call; Ending The Call - Logitech Rally Implementation Manual

LOGITECH RALLY AND RALLY PLUS IMPLEMENTATION GUIDE
6. The LED will flash blue while pairing to a Bluetooth device or while pairing the
remote control to Rally.
f.

SLEEP MODE:

i. A few seconds after a video call is ended, the camera will go into sleep mode and the
lens will point down to the base. This protects the lens and helps keep it clean.
g. MAKING A CALL (IN SUPPORTED APPLICATIONS)
i. After ensuring that Rally, (mic and camera) are selected in the application properties,
select a contact within application or dial a number from application dial pad.
h. RECEIVING A CALL (IN SUPPORTED APPLICATIONS)
i. When a call is being received, the white LED will blink and the application ringer is heard
on the Rally speaker. Press the call answer button on the remote control button or from
the application to start the call.
ii. Rejecting and accepting call waiting takes place within the application.
i. CALL WAITING (IN SUPPORTED APPLICATIONS)
i. If another party calls in during a call in progress:
1. Merging the new caller into the call in progress or putting current call on hold to
talk to new caller takes place within the application.
ii. Rejecting and accepting call waiting takes place within the application.
j. HOLD (IN SUPPORTED APPLICATIONS)
i. Putting a call on Hold is takes place within the application.
ii. When a call is put on hold within the application, the red LED will blink until the call is
taken off hold, at which point the LED returns to white.
k. ENDING THE CALL (IN SUPPORTED APPLICATIONS)
i. Pressing the call end button will end the current call.
ii. Calls can also be ended within the application.
l. SETTING CAMERA PRESETS
i. Setting presets 1 & 2: Once the camera has been positioned and zoomed to the desired
point, hold one of the preset buttons down for two seconds to set the preset. When the
preset is saved the LED on the camera will flash briefly. Thereafter, pressing that preset
button will move and zoom the camera to that point until set in a different location.
ii. Home: By default, the home button will be zero pan/tilt and 1x zoom. Whenever the
camera is started it will move to the home position. To set the home preset: Once the
camera has been positioned and zoomed to the desired point, hold the home button down
for ten (10) seconds to set the preset. When the preset is saved the LED on the camera will
flash briefly. Thereafter, when the camera starts it will move to the home position.
p21