Philips PowerPro Aqua FC6405 Manual page 10

ENGLISH
10
Problem Cause
The output of If the water tank produces an
water is faster uncontrolled and too large
and larger than amount of water, the cap of
normal. the tank is probably not closed
properly.
The strip is not placed
properly in the bottom of the
water tank.
The water flow The strip is blocked by
from the water excessive residue.
tank is reduced.
The microfibre mop is not
placed correctly. It covers the
strip and blocks the water
flow from the strip.
The water tank is empty or
nearly empty.
You use a microfibre mop that
is not supplied by Philips.
Solution
Check the cap and make sure it is fully and
properly closed.
Check the strip and make sure that is fitted
properly in the bottom plate of the water
tank.
Remove the strip as shown in the user
manual, rinse it thoroughly and rub it with a
dry cloth. You can also let the strip soak
overnight in a solution of 1 part vinegar to
3 parts water. Rinse thoroughly after soaking
and rub it with a dry cloth. For more
information, go to www.philips.com/support.
Make sure that the Velcro strips on the mop
and the Velcro strips on the water tank are
perfectly aligned. Also make sure the striped
side of the mop is facing outwards, away
from the bottom of the water tank.
Refill the water tank.
Only use an original Philips microfibre mop.
You can buy these mops in the online Philips
shop at www.shop.philips.com/service or at
your Philips dealer.