Pc Software Tool Introduction; Install Mcuxpresso Ide; Install Lpc-Link2 Software; Cmsis-Dap Or J-Link - NXP Semiconductors QN908 series User Manual

NXP Semiconductors

3.2.1 PC software tool introduction

3.3 Install MCUXpresso IDE

MCUXpresso IDE provides comprehensive compiler supporting QN, Kinetis, and LPC
Microcontrollers.
You can download it from the following URL:
https://www.nxp.com/support/developer-resources/software-development-
tools/mcuxpresso-software-and-tools/mcuxpresso-integrated-development-environment-
ide:MCUXpresso-IDE.
Double-click the file to run and complete the installation.

3.4 Install LPC-Link2 software

LPCScrypt is a command-line based, fast flash, EEPROM, OTP and security
programming tool that supports LPC-Link2 Debug Firmware Programming.
You can download it from the following URL:
https://www.nxp.com/support/developer-resources/software-development-tools/lpc-
developer-resources-/lpc-microcontroller-utilities/lpcscrypt-
v1.8.2:LPCSCRYPT?tab=Design_Tools_Tab.
Double-click the file to run and complete the installation.

3.5 CMSIS-DAP or J-Link

QN9080 DK is shipping out with CMSIS-DAP enabled by default as debugger. All SDK
projects are configured as CMSIS-DAP as debugger.
UM11097
User manual
- QN908x Programming Tool:
https://www.nxp.com/webapp/sps/download/license.jsp?colCode=QN908x-
Programming-Tool-Setup
- Image Editor:
https://www.nxp.com/webapp/sps/download/license.jsp?colCode=QN908x-
Image-Editor
2. Navigate to the folder where you downloaded the PC tools.
3. Click the *.exe files to start the installation.
1. Connectivity QTool is a software tool that runs on a PC and talks with the USB
Dongle to act as a peripheral/central device. It provides ease in the debugging
and development of a QN908x-based device.
2. QN908x Programming Tool is a software tool that runs on a PC and talks with
the QN908x DK for firmware uploading and non-volatile parameters setting via
UART/SWD interface.
Note: Only J-Link is supported when updating firmware via SWD interface by the
QN908x Programming Tool. Update the firmware of QN908x DK debugger by
LPCScrypt to support J-Link. The procedure is elaborated at Chapter 4.
3. Image Editor is a command-line tool used to convert binary file to the required
format, check the help content for details.
Rev.2.0 — 21 March 2018
UM11097
QN908x Quick Start User Manual
© NXP B.V. 2018. All rights reserved.
5 of 16