Advertisement
Installation
9
Connect the two ground wires attached to
the SDI module and the ground wire from
the BB board together to the ground plate
on the connector panel of the monitor
using the supplied +PS 4 × 8 screw.
PVM-14M2U/14M2E/
14M2A
Screw +PS 4 × 8
Ground
wires for
the SDI
module
Ground
wire for
the BB
board
Note
Position the ground wire for the BB board as
near as possible to the connecting panel of
the monitor. Then, fasten it using the cable
clamp, together with the cable connecting
between the CN306 terminal on the Q board
and the CN301 on the A board, and the cable
between the CN401 terminal on the A board
and the CN701 on the C board.
10
Other monitors
Screw +PS 4 × 8
Ground
wires for
the SDI
module
Ground
wire for
the BB
board
10
(Only for monitors except PVM-20S1WE/
20S1WU/20S1WA)
Fasten the cable connected to the CN607
terminal on the power board.
Make sure that the cable does not loosen, and
fasten it with the cable clamps installed on
the monitor.
For 14-inch monitors
PVM-14M2U
PVM-14M4U
PVM-14M4B
PVM-14M2E
PVM-14M4E
PVM-14M2A
PVM-14M4A
Advertisement
