G-Ultra To D5 Smart Wiring; Commissioning The System - CENTURION SYSTEMS D5 SMART Installation Manual

SECTION 8

8.3.5. G-ULTRA to D5 SMART Wiring

G-ULTRA
GND IO1 IO2 IO3 IO4

8.4. Commissioning the System

1. Scan the QR Code in
Figure 89.
2. Select the App Store
applicable to the
operating system being
used, either Apple iStore
or Android Google Play
Store.
3. Download and install the
application.
Alternatively, go directly to the app store of the operating system being used, and search
for the app "MyCentsys Pro". Download and install the application onto the smartphone.
1. Once installed, open the application.
2. From the list of gate operators, select the operator that is applicable to this
installation.
3. Connect to the relevant gate operator.
4. Use the app by following the prompts to configure the D5 SMART.
RELAY 1 RELAY 2
NO COM NC NO COM NC + VDC -
COMPLETING THE INSTALLATION
+12V
COM
page 52
D5 SMART
Control Card
FIGURE 88
Download on the
App Store
Minimum Requirements:
• BLE-enabled mobile phone
• iPhone 5 and above
• iOS8
Get it on
Minimum Requirements:
• BLE-enabled mobile phone
• Android 4.4.2. (KitKat)
FIGURE 89
www.centsys.com