Contour Definitions: One Straight Line (Ang) - Siemens SINUMERIK 828D Programming Manual

9.9.2

Contour definitions: One straight line (ANG)

Note
In the following description it is assumed that
• G18 is active (⇒ active working plane is the Z/X plane).
• The following identifiers have been defined for angle, radius and chamfer:
Function
The end point of the straight line is defined by the following specifications:
● Angle ANG
● One Cartesian end point coordinate (X2 or Z2)
Syntax
X... ANG=...
Z... ANG=...
Fundamentals
Programming Manual, 07/2010, 6FC5398-1BP40-0BA0
(However, the programming of contour definitions is also possible without restrictions with
G17 or G19.)
– ANG (angle)
– RND (radius)
– CHR (chamfer)
ANG: Angle of the straight line
X1, Z1: Start coordinates
X2, Z2: End point coordinates of the straight line
Motion commands
9.9 Contour definitions
247