Status During Part Program Start In Search Run Via Program Test (Cpmprt) - Siemens SINUMERIK 840D Function Manual

14.5.5.13

Status during part program start in search run via program test (CPMPRT)

When starting the part program under block search run via program test (SERUPRO), the
coupling can be activated, deactivated or the current status can be retained. The behavior can
be set separately for each coupling module.
Programming
Syntax:
Designation:
Functionality:
Value:
Example:
Programming
CPMPRT[X2]="ON"
Axes and spindles
Function Manual, 06/2019, A5E47437747B AA
CPMPRT[FAx]= <value>
Coupling Mode Program Test
Defines the behavior of a coupling when the part program starts under
block search run via program test.
Type: STRING
Value range:
"NONE" The current state of the coupling is retained.
"ON" When the appropriate coupling module is created, the
coupling is switched on. All defined leading axis relation‐
ships are activated. This is also performed when all or
parts of these leading axis relationships are active, i.e.
resynchronization is performed even with a completely
activated coupling.
"OFF" The coupling is switched off. When the relevant coupling
module was created without an explicit definition (CPDEF),
the coupling module is deleted. Otherwise it is retained,
i.e. it can still be used.
"DEL" The coupling is deactivated and then deleted.
Default value: "NONE"
Comment
; When the part program starts under block search run via
program test, the coupling to following axis X2 is switch-
ed on.
M3: Coupled axes
14.5 Generic coupling
523