Driving your vehicle
When the shift lever is not placed in N
(Neutral), the following popup will be
displayed on the cluster.
Vehicle with dual clutch transmission :
1. Always carry the smart key with
you.
2. Make sure the parking brake is ap-
plied.
3. Make sure the shift lever is in P
(Park).
4. Depress the brake pedal.
5 Press the Engine Start/Stop but-
ton.
i
Information
• Do not wait for the engine to warm
up while the vehicle remains sta-
tionary.
Start driving at moderate engine
speeds. (Steep accelerating and de-
celerating should be avoided.)
• Always start the vehicle with your
foot on the brake pedal. Do not de-
press the accelerator while starting
the vehicle. Do not race the engine
while warming it up.
7-18
• When you start to drive, move the
shift lever after checking the RP-
M(revolutions per minute) is in the
proper range (under 1000 rpm) by
depressing the clutch pedal and
brake pedal.
After releasing the parking brake,
take your foot off the clutch and de-
press the accelerator slowly while
starting your vehicle.
Starting the diesel engine
To start the diesel engine when the
OQXI040331
engine is cold, it has to be pre-heated
before starting the engine and then
have to be warmed up before starting
to drive.
Vehicle with manual transmission :
1. Always carry the smart key with
you.
2. Make sure the parking brake is ap-
plied.
3. Make sure the shift lever is in neu-
tral.
4. Depress the clutch and brake ped-
als.
5. Press the Engine Start/Stop but-
ton.
6. Continue depressing the brake
pedal until the glow indicator light
(
7. When the glow indicator light (
goes out, the engine will start.
When you start to drive, move the
shift lever after checking the RP-
M(revolutions per minute) is in the
proper range (under 1000 rpm) by
depressing the clutch pedal and
brake pedal.
After releasing the parking brake,
take your foot off the clutch and de-
press the accelerator slowly while
starting your vehicle.
) goes out.
)
Need help?
Do you have a question about the Venue and is the answer not in the manual?
Questions and answers
How to remote start
To remote start a Hyundai Venue:
1. Press the door lock button (1). The hazard warning lights will blink once to confirm.
2. Within 4 seconds of pressing the door lock button, press and hold the remote start button (3) for more than 2 seconds. The engine will start, and the hazard warning lights will blink three times.
3. To stop the engine, press the remote start button (3) again.
Note: The climate system settings will be maintained as they were when the engine was last stopped. If the climate system was off, it will not operate when the engine is started remotely.
This answer is automatically generated
हुंडई कार को Remote को कैसे चलाए
To operate the remote for the Hyundai Venue:
1. Start the Engine and Climate System Remotely:
- Press the door lock button (1). The hazard warning lights will blink once.
- Within 4 seconds, press and hold the Remote Start button (3) for more than 2 seconds. The hazard warning lights will blink three times, and the engine will start.
- To stop the engine, press the Remote Start button (3) again.
2. Unlock the Trunk:
- Press the unlock button once to unlock the trunk.
- Use the liftgate handle button to open the liftgate.
3. Smart Key Functionality:
- When within 28-40 inches of the liftgate with the smart key, press the liftgate handle button to open it.
These steps allow you to control the engine, climate system, and trunk using the remote.
This answer is automatically generated