Advertisement
Advertisement
Table of Contents
Related Manuals for Ayra ComPar KIT 1 MKII
Summary of Contents for Ayra ComPar KIT 1 MKII
- Page 1 ComPar KIT 1 & 2 MKII DMX LED light set with power outputs User manual Any information and illustrations shown in this user manual are subject to change without further notice. User manual version: 3.0 Creation date + author initials: 30-07-2013 RV Revision date + author initials: 11-02-2014 RV...
- Page 2 Introduction Thank you for purchasing the Ayra ComPar Kit. You have either purchased the ComPar Kit 1 or ComPar Kit 2. This user manual is suitable for both products as the products are almost identical. The main difference is the used LED light source.
-
Page 3: Safety Instructions
Safety instructions WARNING! Always keep this device away from moisture and rain! Hazardous electrical shocks may occur! WARNING! Only connect this device to a matching power outlet. This device is intended to work on a specified AC currency. Connecting this device to power outlets with other voltages may result in permanent damage and possible hazardous situations, such as fire or electrical shocks! WARNING! Be careful with every operation of this device. - Page 4 - Familiarize yourself with the functions of the device before use. Do not allow operation of the device by unskilled or unqualified people. - Use of the device in other ways than described in this user manual may cause damage and injury. Ayra can not be held responsible for any damage or injury caused by improper use.
- Page 5 rating. - Do not bridge the fuse with electrical wires, aluminum foil, as the fuse is used for protection against electrical shocks and short circuit. - Always mount the fuse cover back to the fuse compartment. Any information and illustrations shown in this user manual are subject to change without further notice. User manual version: 3.0 Creation date + author initials: 30-07-2013 RV Revision date + author initials: 11-02-2014 RV...
-
Page 6: Box Contents
Box contents Box contents 1x Ayra ComPar Kit 1 or 2 1x lighting stand 1x foot controller with connection cable 1x padded case for ComPar Kit 1 or 2 1x lighting stand bag 1x power cable IEC C13 to Schuko 1x power cable IEC C13 to UK plug 1x signal cable for foot controller (5P aviation –... -
Page 7: Device Overview
Device overview 1. Beam output 2. Tightening knob (for hooks, light effect mounting, etc.) 3. Stand mounting adapter with tightening knobs, for placement on the included standard 4. Double braced lighting stand with extension tube, safety pin and tightening knobs 5. -
Page 8: Important Notice
LED lighting fixtures. Connecting fixtures with a high power consumption (such as fog machines) is not recommended by Ayra. Any load greater than 16A total on the power outputs will also cause the 7A fuse to blow. But in addition to that, chances are high that the circuit breaker of your power circuit may also cut the power, causing other fixtures connected to the circuit to deactivate due to the loss of power. -
Page 9: Setting Up The Unit
Setting up the unit The ComPar KIT series comes with a practical lighting tripod stand. Extract the feet of the stands until they are fully extended. Pull the distance tube out until you reach a proper install height and tighten the knob. Use the included safety pin to ensure that the stand will not be able to slide down. - Page 10 Hour Using time of light Fixture hours,0 ~ 9999 Displays the run time of the fixture. Used by rental companies to determine service/maintenance intervals. UERS version Software version,Ver XXX Firmware software version, not upgradeable by users Foot controller features: Suspend Blackout of the unit (no light whatsoever) Strobe Select color...
- Page 11 This unit has the following DMX-channels and DMX-values: 1 Channel Mode Chase 000-007 Blackout 008-037 Show 01 038-067 Show 02 068-097 Show 03 098-127 Show 04 128-157 Show 05 158-187 Show 06 188-217 Show 07 218-247 Show 08 248-255 Random Show 01-08 3 Channel Mode 000-255 Dimmer 0-100% Green...
- Page 12 Red 2 000-255 Dimmer 0-100% Green 2 000-255 Dimmer 0-100% Blue 2 000-255 Dimmer 0-100% Red 3 000-255 Dimmer 0-100% Green 3 000-255 Dimmer 0-100% Blue 3 000-255 Dimmer 0-100% CH10 Red 4 000-255 Dimmer 0-100% CH11 Green 4 000-255 Dimmer 0-100% CH12 Blue 4 000-255 Dimmer 0-100%...
-
Page 13: Installation And Maintenance
- It is prohibited to install the system by using only safety cables or chains! Warranty is void when any of the above safety precautions are not met. Ayra can not be held responsible if any damage or injury occurs due to improper use of the system. - Page 14 The lenses can be cleaned with a non-aggressive glass cleaning solution, but is not recommended. Ayra recommends to clean the mirror and lens with a fine brush, while removing dust and/or dirt with a vacuum cleaner. Avoid touching the lenses with your bare fingers, to prevent fingerprints on the optics.
- Page 15 DMX lighting troubleshooting If you have any problems with DMX lighting, consult this troubleshooting section to solve any difficulties with your product. If this troubleshooting section does not solve your problem, contact your dealer for more information and help. This troubleshooting section contains the most frequent problems and is not a complete collection of possible faults, defects and solutions.
- Page 16 DMX signal (high) power cables parallel to each other. No DMX terminator Apply a DMX terminator at the end of your DMX-chain Signal loss or distortion in DMX Apply a DMX booster in your DMX values chain after 32 fixtures or less. After a maximum of 32 fixtures the DMX signal needs to be refreshed.
-
Page 17: Technical Specifications
Technical specifications Compact lighting system Equipped with four projectors Projectors individually adjustable Colourful light effects thanks to RGB LED light source Automatic, sound active, master-slave and DMX working modes Two selectable ‘Slave’ modes Microphone sensitivity digitally adjustable for sound active mode Several DMX channel modes (1, 3, 7, 12 or 16 channels) LED-display with menu buttons Display invert...
Need help?
Do you have a question about the ComPar KIT 1 MKII and is the answer not in the manual?
Questions and answers