Fitting The Modules And Components - Festo IFB13-03 Electronic Manual

2. Fitting
2.1

Fitting the modules and components

Festo P.BE-VIFB13-03-EN en 0003c
The valve terminal is supplied from the factory ready fitted. If
you wish to supplement or replace individual modules or
components, please follow the instructions in the following
manuals:
– "Supplementary description of the I/O modules" for fit-
ting the electric I/O modules
– "Pneumatics manual" for fitting the pneumatic modules
– Fitting instructions supplied with the product in the case
of modules and components ordered at a later date.
Please note
Handle all modules and components of the valve terminal
with the utmost care. Pay particular attention to the follow-
ing:
– Make sure that screws are not distorted and not sub-
jected to mechanical stress. Make sure that screws are
correctly aligned (otherwise their threads may be dam-
aged).
– Make sure that the specified torques are not exceeded.
– Avoid misalignment between the modules (IP 65).
– Make sure that connecting surfaces are clean (avoid
leakage and contact faults).
– The contacts of type 03 valve solenoid coils must not be
bent (they are not resistant to bending, i.e. they will
break off if bent backwards).
– Electrostatically sensitive components
Do not touch the contact surfaces of the plug connectors
on the sides of the modules and components.
2-3